ÍÀÇÀÄ

HAWK

998-4

INSTALLATION & OPERATING INSTRUCTION

WIRING

Ðèñ. 1

 

Ðèñ. 2
Ðèñ. 3

PROGRAMMING

A. THE TRANSMITTERS:

Maximum is 4 transmitters. Two modes of programming, one is designated channel, (Button 1 is arm/disarm) the other is auto channel setting. (Button 1 is arm, button 2 is disarm.)

1. Enter:

Turn ignition to "on" position.
Push valet switch 3 times to enter designated channel; if push 6 times it will be auto channel.
1 long chirp to enter their channel programming.

2. Program transmitters:

Press any button on 1st TX, 1 short chirp confirm programmed and ready program 2nd TX.
Press any button on 2nd TX. 2 short chirps confirm programmed and ready program 3rd TX.
Apply the same procedure to program 3rd and 4th, a 3 and 4 chirps to confirm programmed.

3. Exit.

Turn ignition to "off" position, or leave it for 15 seconds. A 3 long chirps to confirm exit.

Note: If more than 4 transmitters programmed, the system only kept the last 4 transmitters.

B. PROGRAMMING OPTIONAL SENSOR (PIR OR DOOR/WINDOW SENSOR)

This system has a very unique interfacing with optional sensor, to extend more protection, such as PIR (IR-73) sensor or Door/Window sensor. (DS-70)

For example, in your garage you can put a PIR for protection. (A device to detect person's movement in a protected area.) If system armed, a person walk through the detect area, the siren inside the car will alarming to raise the attention to the owner.

So the same thing applies in door/window sensor, (A device to detect door/window open.) you may put the sensor to the garage door or window. If system armed, a person opens the door or window, the siren will alarm.

Maximum program 4 different sensor codes.

The programming procedure is the same as above A. THE TRANSMITTERS, The difference is only upon enter you push the valet switch 9 times. (1 long chirp to confirm enters).

During programming, you will need to activate the sensor to let the system program it's code.

C. PROGRAMMING SYSTEM FEATURES:

Total 13 programming features to select. (Factory preset all features to "ON" position)

1. Enter:

Turn the ignition "on" then "off". Within 15 seconds push the valet switch 6 times. (A long chirp.) It is on first stage programming mode.

2. First stage programming features:

Push the valet switch times that equal the feature number you want. Example: Push valet switch 2 times, it's on active/passive arming selection. The siren will chirp 2 times, LED flash 2 times to confirm enter this feature.

Select active arming, turn ignition from "off" to "on". 1 chirp for confirmation.

Select passive arming, turn ignition from "on" to "off". 2 chirps for confirmation.

If you want to program carjacking when the system is in active / passive arming, push valet switch 3 times again. (Siren chirp 5 times, LED flash 5 times) The system will add on the previous valet switch pushing.

Note: Totally push valet switch 7 times, the siren chirp 7 times, and LED with 7 flashes... pause sequence. If push the valet switch again, system will return to feature 1. (Siren chirp 1 time, and LED with 1 flash...pause sequence. It's cycling.

3. Second stage programming feature:

Enter: Turn the ignition "on" then "off". Within 15 seconds push the valet switch 6 times. (A long chirp.) And push & hold the valet switch for over 2 seconds, with 1 long chirp confirmation.

By using first stage programming feature method to program second stage's features.

4. Exit.

During programming, if you don't respond to previous step in 15 seconds, or any time press transmitter's button 1, it will exit programming feature, which indicates by 3 long chirps.

FIRST STAGE:
Push valet switch times: Chirp, LED times Turn ignition from "OFF" to "ON" Turn ignition from "ON" to "OFF"
Show   1 short chirp 2 short chirps
Select   Feature "ON" Feature "OFF"
1 1 Chirp on Chirp off
2 2 Active arming Passive aiming
3 3 Rearm ON Rearm OFF
*4 4 Voltage sensor 3 sec. arming delay. Voltage sensor 30 sec. arming delay.
5 5 Car-Jacking off Car-Jacking on
*6 6 Horn Channel 3
*7 7 Horn Pager
SECOND STAGE:
Push valet switch times: Chirp LED times Turn ignition from "OFF" to "ON" Turn ignition from "ON" to "OFF"
Show   One short chirp Two short chirps
Select   Feature "ON" Feature "OFF"
1 1 Lock/unlock 0.9 sec. Lock/unlock 3 sec.
*2 2 2-pulse unlock off. 2-pulse unlock on.
3 3 Passive door lock on Passive door lock off.
4 4 Ignition on door lock on. Ignition on door lock off
5 5 Ignition off door unlock on Ignition off door unlock off
6 6 Disarm parking light off. Disarm parking light on 30"

NOTE:

For system programming feature all returns to presetting "ON", Turn the ignition "on" then "off"..

Within 15 seconds push the valet switch 3 times. (A long chirp.) Then Press Button 1 and 2 together for 5 seconds, there will be a confirmation long chirp.

* Voltage sensor 3/30 sec. arming delay.

Set 3 sec.: Upon close the door, vehicle's interior light will not light up.
Set 30 sec.: Upon close the door, vehicle's interior light will light up.

* Horn/Pager: First stage # 6 & # 7 (Only one could choose)

Select horn: Feature # 6 and # 7 all set to "ON" position.
Select pager: Feature # 6 set to "ON", # 7 set to "OFF" position.

* 2- pulse unlock off / on:

Set off: For most regular vehicles that require only single pulse to unlock doors.
Set on: For some vehicles that require two pulses to unlock the doors.

OPERATION MANUAL

A. TRANSMITTER OPERATION: (4 buttons transmitter)

For designated channel setting:
Transmitter Button System Function Remark
Button 1 Arm/disarm & door lock/unlock  
Button 1 Panic function Press 3 sec
Button 1 - 1 Arm and delete optional sensor In disarm, press twice.
Button 1 - 1 Disarm and 2 steps door unlock In arm, press twice
Button 2 Channel 2 (trunk) control Press 2 sec.
Button 2 - 2 Passive arming by-pass Press twice.
Button 3 Channel 3 control  
Button 4 Car locator  
Button 1 + 2 both Silent arm/disarm Ignition in "off" position.
Button 1 + 2 both 1 sec Activate car-jacking Ignition in "on" position

 

For auto channel setting
Transmitter Button System Function Remark
Button 1 Arm & door lock  
Button 1 Panic function Press 3 sec.
Button 1 - 1 Arm and delete optional sensor Press twice.
Button 2 Disarm & door unlock  
Button 2 - 2 Disarm and 2 steps door unlock Press twice.
Button 2 Channel 2 (trunk) control Press 2 sec.
Button 3 Channel 2 (trunk) control Press 2 sec.
Button 3 - 3 Passiv arming by-pass Press twice
Button 1 + 3 both Channel 3 control  
Button 4 Car locator  
Button 1 + 2 both Silent arm/disarm Ignition in "off" position.
Button 1 + 2 both 1 sec Activate car-jacking ignition in "on" position

B. LED INDICATORS:

LED Function
Off Disarmed
Slow flashing Armed
Fast flashing Passive arming
On - (solid) Valet mode
1 flashes ... pause Trigger on PIR Door / window sensor
2 flashes ... pause Trigger on trunk/hood
3 flashes ... pause Trigger on door switch
4 flashes ... pause Trigger on sensor

C. CHIRP INDICATORS:

Chirp Function
1 chirp Arm
2 chirps Disarm
3 chirps Defective reminder
4 chirps Disarm / Triggered

D. PARKING LIGHT:

Parking light Function
1 flash Arm
2 flashes Disarm
3 flashes Disarm /Triggered
5 flashes Transmitter low battery.

E. OVERRIDE/VALET SWITCH:

1. OVERRIDE FUNCTION:

Use in emergency, like lost or malfunctions of transmitter. Turn ignition on, within 10 seconds push the override/valet switch, the siren will stop and the system disarmed.

2. VALET MODE:

Vehicle in for maintenance or valet parking, the system will not arm.

  1. Turn ignition on then within 10 seconds push and hold override/valet switch for 2 seconds, the LED will turns on indicates the system is in "Valet mode",
  2. System stay in "Valet mode", transmitter still can remote operating lock or unlock the doors, parking light, pop trunk release and panic function. But no alarm function.
  3. Return to normal operation, turn ignition "on", then within 10 seconds, push and hold override/valet switch for 2 seconds, it will exit the valet.

F. PASSIVE ARMING

It operate as below:

  1. Turn "off" the ignition.
  2. Leave vehicle and close all doors.
  3. LED fast flashing.
  4. After 30 sec. System auto arming Note: during the 30 sec. If open the door the time will stop counting down, until all doors dosed then again restart count down for 30 sec. Passive arming by-pass: Press button 2 twice (designated channel setting), to temporally by-pass passive arming. That's for prevent locking yourself out of the vehicle (For example fill up the gas). A short chirp will confirm this by-pass. Re-open the door will not start the passive arming again. Note- It's only temporally by-pass. When turn ignition 'on - off' or use transmitter to arm or disarm, this by-pass will cancel.

G. ACTIVE ARMING:

  1. Press arm button on transmitter.
  2. The siren will chirp once after 3 seconds the system will be fully arm.

NOTE: Defective sensor reminder: 3 chirp indicate defective sensor occurred.

Special Note: If the system is interfacing with optional sensor, such as PIR or door/window sensor, upon system armed, if the PIR or door sensor triggered, the system will full alarming.

H. ACTIVE DISARMING:

  1. Press disarm button on the transmitter.
  2. The siren will chirp twice to indicate that system disarmed.

NOTE: 1. Tamper disarming: If alarm triggered, upon disarm the system, siren chirp 4 times, parking light flash 3 times.

NOTE: 2. Automatic re-arm: No doors open and no ignition on after disarm; after 60 seconds system auto rearm.

I. PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency. To do so, hold button 1 for 3 seconds, and the system will full alarming. To stop panic, press button 1 again or press disarm button.

J. TRIGGER THE SYSTEM

While system in armed condition, open the doors, hood, trunk or trigger the optional sensors, siren and parking light will turn on to alerting of an intrusion for 30 or 60 seconds. Then it will stop and automatic reset and re-arm. If the one of sensors or detectors still active, the alarm system will sound a maximum of 3 times of 30 or 60 seconds cycles.

K. DOME LIGHT CONVENIENCE DELAY & SUPERVISION

  1. Upon disarming, the dome lights will remain on for 30 seconds.
  2. If the vehicle triggered, the dome light will flashing as the same duration as siren. Note: Turn on the ignition switch or arm the alarm will turn off the dome light.

L. ANTI CAR-JACKING

Warning: If you don't want to have car jacking in this alarm system, be sure to set car-jacking off. (See programming features)

2-timer circuits will function as follows:

First timer:

60 seconds after the ignition is turned on, open the door then close the door, or press & hold transmitter's button 1 and 2 for 1 second. The siren will start alarming, and parking light will flashing.

Within 30 seconds, you will be alert to turn the ignition switch from off to on, and within 10 seconds push valet switch to turn off the car jacking feature. If not, it will enter second timer carjacking.

Second timer:

Totally after 90 seconds from beginning, siren still alarming and parking light still flashing, and the starter disable will activate to prevent the vehicle from starting. Override the system to turn off carjacking. (Ignition from off to on, and within 10 seconds push valet switch)

M. IGNITION CONTROL POWER DOOR LOCK SAFETY SYSTEM.

The vehicle's doors will automatically lock after the ignition key turn "on" (if all doors are closed.) And when the ignition key turn "Off", the doors will automatically unlock.

N. TRUNK RELEASE.

Press and hold button 2 on transmitter for two seconds to remote control the trunk release or other electric devices.

O. CHANNEL 3 CONTROL

Press button 3 (designated channel setting), or button 1+3 together (auto channel setting) to remote control the optional electrical device. The device will "on" when the button(s) press continuously and "off" when the button(s) released.

P. CAR LOCATOR

Press button 4 will active car locate function. The siren will chirp 6 times. The parking light will flash 12 times, for you to easily locate your car.

Q. TRANSMITTER LOW BATTERY: (Random code transmitter only)

When the transmitter is in low battery condition, the system will show up by parking light flash 5 times, to remind the user to change the low battery.

T. ALARM OPERATING CONDITION:

  Siren, horn Parking Light LED Doors Starter disable
1. Arming 1 Chirp 1 Flash Slow flash Locking On
2. Disarming 2 or 4 Chirps 2 or 3 Flashes Fast flash Unlocking Off
3. Trigger Alarming Flashes Slow flash   On
4. Panic Alarming Flashes Slow flash Locking  
5. Car-Jacking Alarming Flashes Slow flash   On
6. Car locator 6 chirps 12 flashes      
5.02.2002