Congratulations on the purchase of the new model VISION remote start car alarm, with this purchase you have taken a great step forward towards the protection of your investment as well as providing you with peace of mind to the security of your vehicle.
The VÀÅ 318-2800 is the most advanced alarm system with build remote start and anti-hijack function which is controlled by 3 channel code hopping transmitter, more than 14 different attractive functions with simple operations, which protect your vehicle for safety and security.
The following pages include Operating Instruction, Diagnostic Instruction and Ignition Programmable Instruction, please follow the instructions described and make sure every function is operating correctly.
With the purchase of your new alarm you have included
The CODE HOPPING transmitter each time it is pressed will randomly transmit a different code. This prevents the thieves from using a code grabber to copy the code and re-transmitting the code to disarm the alarm system.
Four noticeable features.
Note: To replace the batteries in the transmitter, remove the phillips head screws on the under side of the transmitter, gently raise the face cover from the bottom cover, take out old batteries and replace with new one ensuring correct polarity.
Never wet or submerge transmitter in water, as this will invalidate warranty
Operate your transmitter by following the instructions in Table 1.
What function you want to do | What you need to do | Response |
---|---|---|
Active arming (when system is disarmed) | Press CH-1 |
|
Active disarming (when system is armed) | Press CH-1 |
|
Active silent arm/disarm | Press CH-3 | Same response as active arm/disarm except siren will not chirp |
Last door arming | After ignition turned OFF arms within 20 seconds after all doors are closed | Same response as active arming except doors will not lock |
Valet | With ignition ON, press CH-1 for 3 seconds | LED turns ON solid |
Deactive valet | To repeat above procedure | LED turns OFF |
Auto re-arming | Within 60 seconds of disarming if no entry joint is opened | Same response as active arming |
Trunk release (if fitted) | Press ÑH-2 (works only when ignition is OFF) |
|
Trigger alarm (when system is armed) | Any sector is triggered after of 5 seconds exit delay |
|
Deactivate alarm | Press ÑH-1 |
|
Remote start (Only for automatic transmission vehicle, the gear shift must be in P position, emergency brake must be ON, & the hood must be closed) # For vehicles equipped with manual transmission, please call your dealer for optional adaptor |
Press CH-1&CH-2 together for 3 seconds | Indicator flash 6 times to confirm remote start signal is received |
If engine starts, (if fails the system will crank every 10 seconds once, total 6 times) |
|
|
If engine fails to start the engine in 6 attempts, it will give up & enter arm mode | Same response as active arm | |
Drive the vehicle at remote start period | Press CH-1 to disarm (if system is in arm mode). First turn ignition key to ON position. Second release the emergency brake |
|
Anti-hijack Note : To exit anti-hijack mode, you just pressCH-2 & CH-3 together for 3 seconds again in this 40 seconds duration, the system will reset, go back to disarm mode |
Press CH-2&CH-3 together for 3 seconds | 1st 20S
|
2nd 20S
|
||
3rd 20S
|
||
Anti-hijack if you use external relay for fuel pump cut out (arm output #14) | Arm output 1 second escalates to disable fuel pump every 3 seconds Note : if ignition is turned OFF, you can not start the vehicle anymore, you have to deactive anti-hijack. |
|
Deactive anti-hijack (engine is disable) | Press CH-2 & CH-3 together for 3 seconds |
|
Panic | Press CH-1 for 3 seconds (works only when ignition is OFF) |
|
Deactivate Panic | Press CH-1 again | Same response as active arming |
Emergency reset (in case you lost transmitter) | Open the door, wait for 3 seconds, turn ignition key the number of times you programmed you programmed (please refer to Programming Security Code of page 6) |
|
The system is connected by wires linked to the vehicles door, optional sensors, & ignition key switch. Once the alarm is armed the systems intelligent management will monitor these sectors to protect your vehicle.
Please refer to the Protection Sector as follows:
The door sector is very important sector, this protects unauthorized entry and also controls other functions such as last door auto arming, re-arming.
The system provides additional sectors which optional sensors such as dual zone microwave detectors which can be added to the system.
This is final protection of the system if all other sectors an invalid. If the would be thief turns on the ignition switch, the alarm will trigger.
Note : If a sector received three triggers this sector will be switched off.
23.12.2001